Comments on: Raspberry Pi with MATLAB and Simulink https://matlabhelper.com/blog/raspberry-pi-with-matlab-simulink/ Education is our future. MATLAB is our feature. Tue, 24 Jan 2023 19:07:45 +0000 hourly 1 By: الأستاذ وليد بن شوش لرياضيات المتوسط https://matlabhelper.com/blog/raspberry-pi-with-matlab-simulink/#comments/1081 http://matlabhelper.com/?p=2844#comment-1081 This is amazing, thanks for sharing, i have done all of this, turned some LEDs using GPIO pins, and many other stuff, however, i can’t get the ultrasonic sensor from arduino hc sr to work with the raspberry and matlab, can you please post a small thing about it.

]]> By: Abhishek Agrawal https://matlabhelper.com/blog/raspberry-pi-with-matlab-simulink/#comments/490 http://matlabhelper.com/?p=2844#comment-490 In reply to May Sapal Thant.

It happens some time when the user hasn’t formatted the SD card using SD formatting tool and some times due to loose connection between card reader and PC. Please try to format the SD card using proper formatting tool that can be downloaded from sdcard.org and repeat the same process again. Hope this solves your problem !

]]> By: May Sapal Thant https://matlabhelper.com/blog/raspberry-pi-with-matlab-simulink/#comments/489 http://matlabhelper.com/?p=2844#comment-489 Hello.. I use “Set up hardware with Mathworks Rasbian Image”. And in the stage of “Firmware Write”, I can write that firmware to my SD card till the end. But after writing, I can’t “Next” for next stage. It shows “Can’t access SD card”. I can’t continue my way… Kindly advice me.. thank you

]]>